Support
- Total activity 6447
- Last activity
- Member since
- Following 0 users
- Followed by 5 users
- Votes 1
- Subscriptions 5944
Articles
Recent activity by Support-
Why doesn't the hammer drill seem to hammer? It is in the hammer mode and I am squeezing the trigger.
The bit in the chuck needs to be engaged or pushed against a surface for the hammer mode to start. The drill does not hammer in a "no load" condition.
-
What is the detectable temperature range for the TLD100?
The temperature range is -22 degrees F to 302 degrees F (-30 C to 150 C).
-
Is it still okay to use a 100 foot 14 gauge cord with my type one, BV4000, and the pigtail cord installed under terms of the recall?
It is perfectly acceptable to use a 14 gauge 100 foot cord attached to the pigtail on the BV4000, type one, unit.
-
My inflator will run but there's no pressure, what could be the problem?
Unfortunately without examining your inflator we cannot be certain as to why you are having a problem. You would need to take or send your unit in for service.
-
Can the ScumBuster scrubber be totally submerged in water?
Yes, the ScumBuster Cordless Wet Scrubber is designed to be completely submerged in water. We recommend that you only submerge it in 12 inches of water.
-
What type of material is the rubber bristles on the model # BSV2020P made of?
The rubber bristles are made of Silicone.
-
How much line does the AF-100 spool hold?
Pre-wound AF-100 spools come with 30' of line. The spool can hold up to 50' of line if you are rewinding the spool with bulk line.
-
What is the RPM of the blade on the cordless lawn mowers?
For the models CMM1200, CM1836, CM1936 and SPCM1936 the blade RPM is 3600.
-
Where is the battery charging port located on the CM1936ZF2 lawn mower?
The batteries for the CM1936ZF2 can only be charged using the charging port on the batteries. You cannot charge the batteries for this mower through the safety key port on the under side of the swi...
-
What is the PSI on the BDPS400/BDPS600 Paint Sprayers?
The PSI rate for the paint sprayers is 2400 PSI.