Follow the instructions listed below to attach the chuck key to the chuck key holder. Place the chuck key holder on a flat surface and lay the cord of the drill on top of the holder. Push the double-hole end of the holder through the slot in the other end of the holder. Slip the loop over the electric plug and draw the loop tight around the cord. Push the ends of the chuck key handle through the two holes in the end of the holder.
Articles in this section
- How far does the "T" shanked blade go into the jig saw?
- How do I register my new BLACK+DECKER product?
- How do I register my new BLACK+DECKER product?
- How do I register my new Black & Decker product and where do I send the warranty card?
- How can I remove the chuck from my drill?
- Why is the battery bar flashing white on my Black + Decker Multipower 2 in 1 Cordless Vacuum?
- Why is the battery bar flashing white on my Black + Decker Multipower 2 in 1 Cordless Vacuum?
- When do I replace the dust bowl filter on my Black + Decker Multipower 2 in 1 Cordless Vacuum?
- How long do I need to charge my VersaPak® batteries?
- Where can I buy spare parts for my product?
Comments
0 comments
Please sign in to leave a comment.